Perfect for smaller marine applications, the 62GA, Tie Down Engineering/Dexter part number 49501, features a 2,000 pound capacity and a hot dipped galvanized finish. This finish will allow the axle beam to last longer than traditional painted, powder coated, or e-coated axles with more resistance against water and snow environments. The axle has a pre-drilled 5/16" drain hole to allow water to purge itself from the inner tubing. The spring center holes are drilled by the manufacturer at 46.5" center to center.

Product Features:

• Hot dipped galvanized beam to combat corrosion
• Galvanized axles will last much longer than painted ones and are perfect for marine applications
• Features a stainless steel wear sleeve on either spindle
• Straight axle design with no camber
• Includes 2 castellated nuts, 2 washers, and 2 cotter pins
• This axle should not be used with wheels exceeding 12"
• Hubs sold separately
• Flangeless

Product Specifications:

• Capacity: 1,800 lbs.
• Hub Face Measurement: 57.50"
• Overall Length: 62"
• Beam: 1.5" x 1.5" Square
• Spring Center: Pre-drilled at 46.5" center to center
• Spindle: 1" straight

Hardware Information:

• Inner/Outer Bearings (sold separately): 44643 (1" inner diameter)
• Races (sold separately): 44610
• Grease Seal Inner Diameter: 1.25"

Tie Down Engineering/Dexter Marine of Georgia Part Number: 49501